Motorcycle Tech Tips & DIY Garage How-Tos – Cycle Source Magazine
My First Tig: Eastwood Tig 200
Article By: George The Painter Originally Published In The April 2019 Issue Of Cycle Source Magazine I'm not a welder, fabricator or even a grinder for that matter. I’m just a guy that has assembled a little shop to wrench on my bikes and…
In Slide Line: Flat Track Tech
Article By: Tyler Porter Originally Published In The May 2019 Issue Of Cycle Source Magazine I’ll level with you readers this month. Deadline time has come for me once again; I’m getting polite but stern texts from the First Lady of Cycle…
Full Throttle Tech: Wide Open Is In The Blood
Article And Photos By: Daniel Donley Originally Published In The May 2019 Issue Of Cycle Source Magazine A local kid named Evan comes from a family of drag racers. The family has been drag racing and street racing for over 40 yrs. It was…
Thundermax FMS
Putting The Tune On Fleeing And Eluding Article and Photos By: Matt Reel Originally Published In The May 2019 Issue Of Cycle Source Magazine If you recall, a few months back I did an article on the engine build I did on Fleeing & Eluding. If…
Rock Out Of The Rockers
Shimming A Faith Forgotten Choppers Springer Article And Photos By: Will Ramsey - faithforgottenchoppers.com Originally Published In The May 2019 Issue of Cycle Source Magazine Springers often get a bad rap due to handling issues. Sometimes this…
Taillight Install Tips from Flat Broke Chops & Rods
Article and photos by Chris Callen, originally published June 2019 For the record, this is a simple tech, but one I struggled with early on so for what it’s worth, I’ll pass it on here. If you have ever faced drilling a blank fender for a…
Pandemonium Custom’s Shop Tech – 4 N 1 Tool
Sometimes You Just Gotta Make Your Own Article by Daniel Donley Inspired by Erie Hull Originally published June 2019, Cycle Source Magazine I have a small shop and the same size budget to go along with it. When I have time or extra money I…
Lectron Carb – Magoo Checks In With The Install & Tune
Article and photos by Mitch "Magoo" Bodine Lectron carbs have been made in USA since 1974. They where actually OEM on some Harley models in the late 70’s. I first used Lectron carbs in the late 70’s on two various two stroke street…
Tech Tid Bits, Unseen Tech From the Cutting Room Floor
“Tech Tid Bits” Unseen tech from the cutting room floor by Daniel Donley Originally Published August 2019 “Doin’ The Ton”, what does that mean? It means you’re going 100 miles per hour or more. Last month I finally achieved my 100th Tech Article…
Lift It -Mallett Competition Products Lifting Spools
People have been modifying Harley-Davidsons since the beginning of their time. From basic repairs just out of necessity to performance upgrades. The Dyna platform, in my opinion, has always been Harley’s hot rod. Its light chassis and large…
Top Stories
