The Purge: Shielding A Stainless Steel Exhaust Weld

Article and Photos By: Will Ramsey Originally Published In The January 2019 Issue Of Cycle Source Magazine   A well designed and properly fabricated stainless steel exhaust can be the absolute highlight of a custom motorcycle, both in looks and performance. Week after week we have service customers walking in the door looking for the Read More >

Developing A Designers Eye: Fabricating A Stainless Steel Sissy Bar

Article By: Will Ramsey Photos By: Craig Harriman (Corey Took One) Faith Forgotten Choppers – www.faitforgotten.com Originally Published In The March 2019 Issue Of Cycle Source Magazine   It has been a while since I did an “off the cuff” fabrication tech. This month I happen to be fabricating a very simple traditional sissy bar Read More >

Rock Out Of The Rockers

Shimming A Faith Forgotten Choppers Springer Article And Photos By: Will Ramsey – faithforgottenchoppers.com Originally Published In The May 2019 Issue of Cycle Source Magazine Springers often get a bad rap due to handling issues. Sometimes this is due to poor geometry in the design that creates excessive trail (either negative or positive), and sometimes Read More >

May 2020 Digital Issue For Your Reading Pleasure!

May 2020 – Issue 278 Is packed with goodness! A new contributor, Troy Bensinger tells the tale of Corn Free a neat little bike event, that’s not your usual chopper gathering. Magic Missi recaps the 2019 Cross Country Motorcycle Chase and Twig takes a gander back to the Hard Times Chopper Show.  We’ve got five Read More >

Hardtailing A Stock 4 Speed Frame

To Read The Full Article, Go To www.cyclesource.com Article By: Will Ramsey Originally Published In The September 2018 Issue Of Cycle Source Magazine   As the Grease & Gears stage continues to travel and evolve, so does the level of presentations and fabrication techniques. With the addition of some serious audio and video equipment, as Read More >