Article By: Wayne At Wicked Willy’s Choppers www.wickedwillychoppers.com In part ten of the beer runner, we will build an oil tank for the trike. It is a very simple tank that will mount inside the swingarm, but it will be built just like any other tank we build for a dry sump motor. It will Read More >
Wicked Willy’s Choppers
Beer Runner on a Budget–Part 8
Article By: Wayne at Wicked Willy’s Choppers Here in part 8, we will finish our foot clutch that we started last month. We will make an end for our cable and also make up a set of kickass handlebars that flow with our tank and have enough pullback for this long trike. Then I will Read More >
Beer Runner On a Budget–Part 7
Article By: Wayne at Wicked Willy’s Choppers Here in part seven of our trike build, we are going to start our foot controls. I will be building a custom foot clutch using our own forward controls. This will take two parts because I will show you how to measure and make your own cable out Read More >
Beer Runner On A Budget
Article By: Wayne at Wicked Willy’s Choppers In this section, we are going to build a gas tank from scratch. I will be using 18 gauge sheet metal and our tank will be a little radical because instead of sitting on the top of the frame, it will actually fit between the frame. You Read More >
Beer Runner on A Budget
Article by: Wayne at Wicked Willy’s Choppers Wicked Willy’s Beer Runner on a Budget – Part 4 In part 4 of this segment, we got the frame and rear end back in our shop. I will set the pre-load on my shocks and set my ride height of the frame so I can start machining Read More >