Tech Tips/ DIY
Speedo Install
Article And Photos By: Matt Reel Originally Published In The March 2019 Issue Of Cycle Source Magazine As some of you may recall, my Fleeing & Eluding Sportster was a theft recovery that was involved in a police pursuit in my town…
Developing A Designers Eye: Fabricating A Stainless Steel Sissy Bar
Article By: Will Ramsey Photos By: Craig Harriman (Corey Took One) Faith Forgotten Choppers - www.faitforgotten.com Originally Published In The March 2019 Issue Of Cycle Source Magazine It has been a while since I did an “off the cuff”…
Pay Attention, It’s Free
Article And Photos By: Daniel Donley Originally Published In The March 2019 Issue Of Cycle Source Magazine Here we are at the beginning of a new year. There is one tool in a shop that you really don’t think about as being a critical tool.…
Cam Cover Install
Article and Photos By: Matt Reel Originally Published In The April 2019 Issue Of Cycle Source Magazine Recently while getting Fleeing & Eluding ready for some Dyno Tuning at Zippers Performance I installed a billet sprocket cover from…
El Diablo 2 Into 1
Article And Photos By: Patrick Garvin Originally Published In The April 2019 Issue Of Cycle Source Magazine It’s no secret that I love Sportsters. Over the years I’ve dumped a ton of money into these inexpensive yet awesome machines. But just…
Installing A Dirty Tail Kit
Article and Photos By: Chris Callen Originally Published In The April 2020 Issue Of Cycle Source Magazine In the year nineteen hundred and eighty four, the Harley-Davidson motor company would revolutionize the custom culture surrounding…
Hot Rod Air: Going For The Flow
Article and Photos By: Daniel Donley - Pandemonium Custom Choppers Originally Published In The April 2019 Issue Of Cycle Source Magazine Last months tech article “Pay Attention… Its’ Free” covered preventative maintenance procedures for…
My First Tig: Eastwood Tig 200
Article By: George The Painter Originally Published In The April 2019 Issue Of Cycle Source Magazine I'm not a welder, fabricator or even a grinder for that matter. I’m just a guy that has assembled a little shop to wrench on my bikes and…
In Slide Line: Flat Track Tech
Article By: Tyler Porter Originally Published In The May 2019 Issue Of Cycle Source Magazine I’ll level with you readers this month. Deadline time has come for me once again; I’m getting polite but stern texts from the First Lady of Cycle…
Full Throttle Tech: Wide Open Is In The Blood
Article And Photos By: Daniel Donley Originally Published In The May 2019 Issue Of Cycle Source Magazine A local kid named Evan comes from a family of drag racers. The family has been drag racing and street racing for over 40 yrs. It was…
